DLP Lean Angle Sensor Delete Module
The factory Lean angle sensor in the YXZ is designed to shut off the engine during a tip or rollover and requires a key cycle to reset the system. This may be great to have while trail riding, but it is not ideal while on the race track.
This module replaces the factory lean angle sensor and will prevent your YXZ from shutting off during a tip or rollover
Eliminate the risk of a faulty lean angle sensor costing you the race
Simple plug and play installation
For use on a closed course with safety personal present
**CAUTION** you will need to cycle the power off when rolled upside down or vehicle may continue to run
Installation instructions
-
Locate the lean angle sensor (located just behind the battery, in the center console, and has two bolts mounting it to the rear firewall)
-
Disconnect the sensor connector and plug in the delete module
-
If desired, the lean angle sensor can be completely removed from the vehicle
⚠WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
